PCB Layout

PCB Stamp Holes: Definition & Design Requirements
2026-04-24
Stamp holes are perforated holes on a mainboard panel used to connect small PCBs arranged in an array, allowing easy removal of individual modules from the PCB assembly.
Routing Techniques for PCB Layout Design
2026-04-24
The quality of PCB layout directly affects the performance of the entire system, and most high-speed design theories must be ultimately implemented and verified through layout. Therefore, routing is critical in high-speed PCB design. This document analyzes the rationality of common routing scenarios in practical design and provides optimized routing strategies, focusing on three aspects: right-angle traces, differential traces, and meander traces.
PCB Trace Width vs. Current Capacity Guide
2026-04-24
This article explains how to select trace width for high‑current designs based on IPC‑2152 and IPC‑2221 standards, focusing on temperature rise control.
What is Crosstalk and How to Fix It?
2026-04-23
As electronic frequencies rise and PCBs become denser, crosstalk has become a critical signal integrity and EMC issue.
DDR4 PCB Routing Guide & PCB Architecture Improvements
2026-04-23
As computer technology evolves, PCB architectures must be updated to match new standards—including the shift from DDR3 to DDR4. This article explains key changes and routing rules for DDR4 implementation.
PCB Layout Notes Handbook
2026-04-23
This article is a practical PCB design and layout guide for engineers, covering component placement, routing, copper pouring, soldering files, structure, and DRC check.
Brief Introduction to Methods for Suppressing Output Ripple Voltage
2026-04-23
Switching power supplies are widely used due to high efficiency, wide adjustable output voltage, low loss, small size and light weight. However, their stable DC output is often accompanied by an AC component called voltage ripple. Excessive ripple shortens service life and causes noise, so it must be controlled within acceptable limits.
Why Do MLCC Ceramic Capacitors Cause Noise/Whistling?
2026-04-23
Sound comes from vibration. Audible noise (20 Hz – 20 kHz) from MLCCs means the capacitor vibrates under AC voltage (typically < 1 nm displacement).
Go to page