PCB Layout

Technical News | When Do Layout Decisions Become Signal Integrity Problems?
2026-11-06
Signal integrity (SI) problems in high-speed PCBs are usually not caused directly by schematic errors, but are jointly determined by routing topology, via layer-transition strategy, and stack-up material selection. Continuous reference planes, adjacent stitching vias, reasonable control of via stubs, and material selection based on Dk and Df are key to reducing return-path discontinuity, via resonance, signal loss, crosstalk, and EMI risk.
Understanding PCB Loss Curves: First Separate the Two Variables
2026-11-06
For the same flexible microstrip, insertion loss drops noticeably after changing to another process, yet the report directly states, “the copper surface is smoother, so loss is reduced.” This conclusion may be too hasty: if the copper conductor cross-section, adhesive layer, and surface condition all changed together, the improvement of the entire process cannot be attributed entirely to one factor. Reading a loss report is not just about finding the lower curve;
The Copper Beside Traces: More Is Not Necessarily Better
2026-11-05
Pouring ground copper into blank PCB areas is very common, but when copper pour is close to high-speed or RF traces, it may directly change impedance and field distribution. This article explains from three perspectives—microstrip, coplanar structure, and spacing—when copper should be poured and when distance should be kept.
Five Major Taboos in PCB Layout: How Exactly Should Crystal Oscillator Traces Be Routed?
2026-11-05
Many hardware engineers treat a crystal oscillator as an ordinary small resistor and place it casually during PCB layout. Only after the board comes back do they discover that clock jitter exceeds the specification, the oscillator fails to start at low temperatures, or EMC radiation testing fails—and the rework cost multiplies several times over.
Practical Observations on EMI Reduction in High-Speed PCB Design
2026-11-04
This document was written based on practical observations of electromagnetic interference from high-speed signals and power switching, which can cause process failures. Layout and schematic design recommendations for components used in a product may be provided in datasheets, but actual observations and solutions may differ.
How to Use PCB Holes to Effectively Reduce EMI
2026-11-04
Mounting holes in PCBs are important elements in electronic design. Every PCB designer will learn about the purpose and basic design of PCB mounting holes. Moreover, when mounting holes are connected to ground, some unnecessary trouble after installation can be avoided.
PCB Impedance Design Matching: Ideal Model and Methods
2026-11-03
In electrical engineering, the opposition to current in a circuit is often called impedance. The unit of impedance is the ohm, commonly represented by Z, and it is a complex number:
Introduction to PCB Layer Stack-Up Structure
2026-11-03
Altium Designer Layer Introduction
Go to page