PCB Layout

Analysis Method for PCB Transmission Line Structure
2026-06-04
To learn high-speed PCB design, the first thing to understand is what a transmission line is. Signal reflection occurs because the traces on the PCB have a certain impedance, and the impedance mismatch between the line impedance and the output impedance will lead to signal reflection. Signal transmission in the PCB will cause delay, and if the timing is not matched, the system will fail to operate. All these problems are caused by transmission lines.
31 Design Rules for PCB Trace Width and Spacing
2026-06-03
It is believed that when doing PCB design, everyone will find that the routing link is indispensable. The rationality of routing determines the aesthetics of the PCB and its production cost, and also reflects the quality of circuit performance and heat dissipation performance, as well as whether the performance of the device can be optimized.
How to Handle Heat Dissipation Issues in the PCB Design Process
2026-06-02
In modern high-performance electronic devices, heat dissipation is a common and critical issue. Proper handling of heat dissipation is essential to ensure the reliability, stability and service life of electronic devices.
What Principles Should Be Followed in PCB Routing
2026-06-02
interface signals operating at a rate of 8Gbps and above have stricter requirements for PCB routing design due to their extremely high speed. On the basis of the previous PCB routing content, the PCB routing design must also comply with the requirements specified in this article.
PCB Layout and Routing Requirements for SATA3.0 Interface
2026-06-01
SATA is the abbreviation of serial ATA, namely Serial Advanced Technology Attachment. It is a computer bus, whose main function is to realize data transmission between the motherboard and mass storage devices (such as hard disk drives and optical disc drives).
Should Isolated Copper Be Removed in PCB Design?
2026-05-30
Do you know whether isolated copper should be removed in PCB design? There are numerous issues that require attention in PCB design techniques, and the compatibility of various components, as well as finished product issues, are all important factors to be considered. The topic of our discussion today is whether isolated copper should be removed during PCB design.
Go to page