PCB Layout

Why Are Some GND Pads Still Not Connected Even Though the Ground Copper Has Clearly Been Poured?
2026-11-12
Why Are Some GND Pads Still Not Connected Even Though the Ground Copper Has Clearly Been Poured?
High-Speed Signal Layer Transitions: Why Must Return Vias Be Placed Right Next to the Signal Via?
2026-11-11
The signal via is only responsible for moving the signal to another layer. Whether the return current can cross layers nearby determines whether this layer transition is complete.
RF Circuit PCB Design Techniques!
2026-11-10
Since RF circuits are distributed-parameter circuits, skin effect and coupling effect are likely to occur during actual circuit operation. Therefore, in actual PCB design, it is often found difficult to control interference radiation in the circuit, such as mutual interference between digital and analog circuits, noise interference from the power supply, and interference caused by unreasonable ground routing.
PCB Teardrops Can Reinforce Connections, but Should Be Used Cautiously on High-Speed Signal Traces
2026-11-10
The connection root between a pad and a thin trace is easily weakened by drill misalignment, process variation, and stress. Teardrops add copper precisely at this weak point. However, adding teardrops to the entire board with one click may also suddenly widen the originally uniform geometry of high-speed traces.
Building an Effective Crystal Oscillator Circuit from Scratch: Full Steps from Component Selection to PCB Implementation
2026-11-09
In various electronic systems such as embedded systems, optical modules, and automotive BMS, the crystal oscillator circuit is the clock heart of the entire device. About 80% of the problems engineers encounter—failure to start oscillation, frequency drift, and EMC exceeding limits—come from oversights in crystal oscillator circuit design details.
Technical News | Why HDI Fails in Real Applications: Deeper Causes Beyond Microvia Cracks
2026-11-09
Long-term failures of HDI PCBs are usually not caused by a single defect, but by the combined effects of materials, lamination processes, copper distribution, dielectric layer thickness, moisture, contaminants, and operating stress.
No Idea for PCB Layout? Start by Placing These Four Types of Positions
2026-11-07
The schematic is done and the components have been imported into the PCB. Facing a tangled mess of ratlines, do you not know which one to move first? Some people put the large chip in the middle first, some arrange components around the board edge, and others stuff them wherever there is space.
Package Is Wrong, No Matter How Beautiful the Routing, It Won’t Fit
2026-11-07
If the Package Is Wrong, No Matter How Beautiful the Routing, It Won’t Fit
Go to page