PCB Assembly

How to Control PCB Assembly Costs?
2026-07-07
PCB assembly cost is a concern for every electronic engineer or designer who wants to know how to get the best PCB assembly quote and how prices affect PCB assembly costs. Here are some tips to guide you on how to control PCB assembly prices.
Difficulty Analysis and Solutions for Flux Residues
2026-07-06
"Flux residue during reflow soldering of low-temperature solder paste" refers to a certain amount of flux remaining on solder joints or in the soldering area because the flux used in the soldering process cannot be completely volatilized or decomposed during reflow soldering with low-temperature solder paste.
Brief Discussion on PCB Assembly Design Techniques
2026-06-23
As an NPI engineer, DFM (Design for Manufacturability) analysis covers a wide range of aspects, which is highly relevant to today’s topic—PCB assembly design techniques. This article focuses on PCB Assembly Design (DFA, Design for Assembly) and practical tips for PCB assembly design.
Soldering Principles of Reflow Soldering and Wave Soldering
2026-06-20
When a PCB enters the preheating zone (drying zone), solvents and gases in the solder paste evaporate. Meanwhile, the flux in the solder paste wets the pads and connector pins; the solder paste softens, collapses, and covers the pads, isolating the connector pins from oxygen.
PCB Soldering Issues, Wave Soldering Defects and Preventive Measures
2026-06-19
This article covers PCB soldering issues, wave soldering defects and corresponding preventive measures.
A Brief Discussion on Common Causes of PCB Pad Peeling
2026-06-18
During the use of circuit boards, pad peeling often occurs, especially during circuit board rework. When using an electric soldering iron, pad peeling is very likely to occur. How should PCB manufacturers respond? This article analyzes the causes of pad peeling.
What is the Role of Solder Paste Inspection (SPI) in the SMT Production Process?
2026-06-18
More than 50% of PCB component solder joint defects can be traced back to incorrect or suboptimal solder paste printing. While good solder paste printing practices are usually sufficient for small-batch production, solder paste inspection (SPI) should be carefully considered for high-volume printing.