In PCB design, dead copper, that is, isolated copper, is a common problem, which refers to copper areas that are isolated on the circuit board without electrical connection. However, many electronic engineers are worried about whether to remove dead copper when they meet it. The following article will analyze it from multiple angles, hoping to help friends.
In PCB design, dead copper, that is, isolated copper, is a common problem, which refers to copper areas that are isolated on the circuit board without electrical connection. However, many electronic engineers are worried about whether to remove dead copper when they meet it. The following article will analyze it from multiple angles, hoping to help friends.
1. What problems can dead copper bring?①EMI problem: Dead copper may form antenna effect on the circuit board, enhance the radiation intensity around it, and accept external electromagnetic interference, thus affecting the normal operation of the circuit;
② High-frequency noise: In high-frequency circuits, dead copper may become a tool for noise propagation, resulting in circuit performance degradation.
2. Why should we keep the dead copper?① Aesthetics: Removing dead copper will leave a large blank area, which is not beautiful;
② Mechanical properties: vector dead copper can enhance the mechanical strength of the circuit board and prevent the bending phenomenon caused by uneven stress.
3. How to deal with dead copper?① Try to remove the dead copper: in order to reduce EMI and high-frequency noise, try to remove the dead copper. For the dead copper to be retained, it should be well connected with GND through the ground hole to form a shielding layer;
② Keep the dead copper properly.
However, if we want to consider the aesthetics and mechanical strength of the circuit board, we can keep some dead copper properly. It should be noted that these dead copper must be connected to GND through ground holes to avoid the formation of antenna effect;
③ High-frequency circuit treatment: In high-frequency circuits, the dead copper must be removed. Even if it cannot be removed, special attention should be paid to the treatment method of the dead copper. In addition to connecting with GND through the ground hole, the wiring spacing must be less than λ/20(λ is the wavelength of noise frequency) to reduce the spread of noise.
④ Comprehensive consideration: In actual design, whether to remove the dead copper should be considered comprehensively according to the specific requirements and working environment of the circuit. For complex circuits and high-frequency circuits, it is suggested to carry out simulation analysis and actual test to determine the best treatment scheme.
About Maxipcb
Maxipcb empowers innovators to turn cutting-edge technologies into reality.
We offer one-stop solutions for design, simulation, testing, PCB manufacturing, component procurement and SMT assembly, enabling efficient development, rapid deployment and risk control across the full product lifecycle.Serving the world in communications, industrial automation, aerospace, automotive, semiconductor and beyond, we build a safer, more connected future together.