In high-frequency PCB design, designing the power supply as a dedicated layer is far superior to bus-based design in most cases, as it allows the circuit to always follow the path of minimum impedance. Additionally, the power plane must provide a signal return path for all signals generated and received on the PCB, which minimizes signal loops and thereby reduces noise—an aspect often overlooked by low-frequency circuit designers.
In high-frequency PCB design, designing the power supply as a dedicated layer is far superior to bus-based design in most cases, as it allows the circuit to always follow the path of minimum impedance. Additionally, the power plane must provide a signal return path for all signals generated and received on the PCB, which minimizes signal loops and thereby reduces noise—an aspect often overlooked by low-frequency circuit designers.
In high-frequency PCB design, we should adhere to the following principles:
- Unified and stable power supply and ground.
- Careful routing and proper termination can eliminate reflections.
- Careful routing and proper termination can reduce capacitive and inductive crosstalk.
- Noise suppression is required to meet EMC requirements.
Material Requirements for High-Frequency Circuit Board Manufacturing
- Dielectric Loss (Df): Must be very small, as it primarily affects signal transmission quality. The lower the dielectric loss, the smaller the signal attenuation.
- Water Absorption: Must be low, as high water absorption will alter the dielectric constant and dielectric loss.
- Dielectric Constant (Dk): Must be small and stable. Generally, a smaller Dk results in better signal transmission speed, which is inversely proportional to the square root of the material's dielectric constant. A high dielectric constant can easily cause signal transmission delay.
- Thermal Expansion Coefficient: Must match that of copper foil, as mismatch during temperature cycling will lead to copper foil delamination.
High frequency is generally defined as frequencies above 1GHz. Currently, the mainstream high-frequency substrates are fluorine-based dielectric materials, such as Polytetrafluoroethylene (PTFE), commonly known as Teflon.
Precautions for High-Frequency Circuit Board Processing
- Strict Impedance Control Requirements: The control of relative line width is extremely strict, with a general tolerance of approximately ±2%.
- PTH Adhesion Enhancement: Due to the special properties of the substrate, the adhesion of Plated Through Holes (PTH) is poor. Therefore, plasma treatment equipment is usually required to roughen the holes and surfaces to improve the adhesion of PTH copper and solder mask ink.
- Surface Treatment Restriction: Do not mechanically grind the board before soldering, as this will severely degrade adhesion. Only micro-etching solutions and other chemical roughening methods are allowed.
- Special Milling Tools: Most high-frequency substrates are PTFE materials. Conventional milling cutters will produce excessive burrs during profiling; special milling cutters must be used.
High-frequency circuit boards are special PCBs designed for high electromagnetic frequency applications. Typically defined as operating above 1GHz, they require superior physical properties, high precision, and advanced technical parameters. They are widely used in automotive collision avoidance systems, satellite systems, radio systems, and other fields.