Smart bracelets, as a popular product category over the past two years, have attracted increasing attention. While not universally accepted, their emergence has indeed brought about some changes in the consumer electronics market.
A typical smart bracelet is composed of an RF circuit unit, a clock circuit unit, a memory circuit unit, a sensor circuit unit, and a main MCU unit. These circuits are usually concentrated within a small board area, with either single‑side or double‑side surface mounting, and the PCB is typically 4‑layer or 6‑layer. The figure below shows the PCB of a 37° smart bracelet found online.
Since so many functions are packed into a relatively small PCB, special attention must be paid to component placement and routing. Below are some key considerations for reference.
1. Partitioned Layout and Trace Protection
As can be seen from the PCB above, the various functional blocks (marked by different coloured boxes) are well partitioned. Since smart bracelets are collections of digital circuit components, proper placement of supporting resistors and capacitors can implement functional circuit modules, making the circuit design cleaner and easier to debug. Although some sensor circuit units use analogue techniques for data acquisition, once that module is designed as a block, data communication and information transfer can be accomplished through corresponding interface connections.
When laying out circuit modules, on one hand, clock and crystal oscillator circuits must reach their target pins via the shortest possible paths. On the other hand, clock traces should avoid data lines to prevent interference that could affect system stability.
During routing, critical traces – such as clock‑generation circuits and crystal oscillator circuits – should be protected. For example, consideration should be given to whether copper pour shielding or guard ring grounding is needed; typically, the area under the crystal is kept clear of copper.
2. Proper Handling of RF Circuits
Smart bracelets need to communicate with smartphones, so the wireless RF section is critical and deserves special attention. Most smart bracelets on the market use Bluetooth for wireless data transmission, so we will focus on Bluetooth RF handling. If the bracelet is used only for data transfer without audio streaming, low‑energy Bluetooth is the best choice. During design, the antenna shape, antenna placement, and bracelet housing material are all important factors affecting performance. A skilled RF antenna engineer is particularly valuable during the PCB design phase.
3. Good ESD Protection
In previous articles, I have written about ESD techniques. Today, I will emphasise the importance of ESD protection for smart bracelet products. Different countries and regions have different ESD requirements for various products. To pass relevant certifications, ESD protection measures must be incorporated during design, and ESD testing should be conducted after completion to ensure the product meets local market standards.
4. Reserve System Upgrade Interfaces
The ease of firmware upgrades is important for users and enthusiasts. If a product can be updated with software upgrades (whether to enable features that were hardware‑ready but software‑unfinished, or to fix software bugs), it signals ongoing development, which provides good psychological reassurance to users. Currently, two common upgrade methods are used: via USB and via wireless push. The choice depends on early planning and co‑ordination between hardware and software development.
About Maxipcb